2008 800 Engine issues
Ok so here is the issue. The engine is using an excessive amount of oil. So fearing the worst I started to investigate the need for a top end rebuild. Checking the compression revealed that both...
View ArticleShocks from a 2013 RZR 800
Hey everyone, I have a buddy who is upgrading his 2013 RZR 800 suspension to the superATV S kit. He offered me his shocks/springs. Is there any difference from the ones that came on the 2008? My 08 has...
View ArticlePolaris Seat Adjuster Kit Review
I purchased the Polaris seat adjuster kit (Part # 2877390) for my wife's 570 and installed it last night. It's the same part number for the 800's so I thought I would add my review to this section as...
View Article800 backfiring
my 09 rzr 800 has been back firing. went out today and it is more often and louder. any suggestions? plugs, better gas????
View ArticleClik here to view.
Is this head gasket leak?
I was looking at my 2011 ranger rzr 800 today and seen there was quite a bit of oil or something all over the engine and belt housing and it looks like head Gaskets are bad but I'm not 100% sure. Could...
View ArticleI give up!!
Ok for some reason rzr sat a week, wkend comes around, I'm going riding, (wrong) battery dead, boost it, cool, all good, made a round or two, notice battery on gauge was 14.3 and dropping, ok let's...
View ArticleBest doors
I am looking for some doors and was wanting some opinions on the different styles and brands.
View ArticleSo I pulled the trigger
Saturday I got a wild hair and bought a brand new 2016 rzr 1000S. All I can say wow it's quick and refined. Still love the little 800 but the 1000S is really cool. I called my cousin and told him about...
View ArticleRzr 800 big bore kit
What is the compression for a 2010 rzr 800 with trinity racing big bore kit. I have called trinity racing and they say they no longer make the big bore kit so they can not tell me what the comoression...
View Article2012 800 u joint
I have a 2012 rzr 800 s and my driveshaft u joints are getting sloppy. Does anyone have the cross reference u joints for a parts store instead of ordering from Polaris and waiting to receive Thanks!
View ArticleGood axle replacement for RZR 800 with 2" lift
I'm looking for some new axles as the the replacement ones I bought lasted all but 300 KM . They were the 8Ten, and they have so much play in them I don't want to reinstall them after replacing all my...
View ArticleRZR 800 oil pump question
Hi, group, has anyone released a high volume oil pump for the 800 engine yet? Thanks, Doug
View ArticleParking Brake Option
Hey there 800 riders, I have a question to pose to those that may be looking for an affordable parking brake for your ride. We currently offer a very in-expensive parking brake for the 1K models, and...
View Article2012 RZR 800 driveshaft
Ok I have an annoying jingle, sounds like it coming from the drive shaft(s), am I correct? and if so, is there an upgrade I can do to better the part And not have a problem?
View Article2012 Rzr 800 50"
Falls on its face. In low range I do not notice much of a difference, but in high range it seems to have a cut out.. can only get to maybe 45 mph. Just seems to have a loss of power. Just put NGK BKR7E...
View ArticleTire question
2013 800 stock Ok to run 26"-27" tires ? Opinion on 9" on front and rear?
View ArticleMaster cylinder
Is there a rebuild kit for the master cylinder on a 2013 rzr 800? Oil is dripping out of the plunger boot and running down the floorboard. I can't find a kit. Everyone want to sell you a new...
View ArticleMonster box programmer
I just bought my self a second hand monster box for my rzr 800 wondering if anyone may have any instructions on programming them thanks
View ArticleOil Drain Plug
Need part numbers for oil drain plug and crush washer. Dealer could not find it?? 2014 RZR EPS
View Article