2008 rzr 8005 fuel issue
ok so I just got a 2008 rzr 800s. took her out for about 5 hours with no real problems except the front 4x4 was not working. watched some vids on youtube and found out the Sprague gear was my issue....
View ArticleClik here to view.
Replacing 2008 rzr fuel tank with 2011-2014 tank
Im tired of fighting the constant fuel leak of my stock fuel tank, picked up a fuel tank off of eBay ($120) for a 2011-2014 rzr S. Could e swore I read somewhere it was a direct swap, my memory...
View ArticleClik here to view.
Another inexpensive e-brake
Made with wire rope, two pulleys and a large washer. Press the brake and hook the washer on to the nut. Very simple and inexpensive. Attached Thumbnails
View Article2012 800 pinion nut loose!
Just removed differential.....made some tools(thanks guys) and removed pinion nut.I used torque wrench and set it at 40 lbs to remove the nut and it came off before the wrench clicked....I would guess...
View ArticleSteering rack and pinion.
Hi guys and gals. I have a 2014 Rzr 800 trail. I replaced the a-arm to superatv high clearance a-arms. And also the heavy duty tie-rods. So my buddy changed them and took the rack out. Long story...
View Articlesplined coupler for pinion nut repair tool
Found this cheap splined coupler that I used to make holding tool for pinion.Its 1 inch id with 15 lands or grooves,2.25 inches long....$9.20. https://www.surpluscenter.com/Brands...615-1-1561.axd
View ArticleAnyone still out there wippin the 800s around?
Just seeing if Im the only that still has an 800s Sent from my iPhone using RZRForums.net
View ArticleSealing front of tub
Anyone try to seal the seam on the front of the tub/firewall? Looking for ideas besides duct tape
View ArticleDoors
Anyone got a set of doors for sale? Id buy them new but theyre just gonna get beat up so I figured see if anyone has a set for sale first Sent from my iPhone using RZRForums.net
View ArticleAir filteration
Early 08 and new to me. In the middle of a top end due to a K&N and some home made box it was mounted in dusting the engine. Full of oil and 17 miles later barely a drop on the stick. Looking at a...
View ArticleYearben shocks
I was going to read up on the yearben shocks. But for some reason I cant find them. Anyone have a link for them? Sent from my iPhone using RZRForums.net
View Articleintermittent 4 WD engagement.
The 4 WD on my 2010 RZR800 comes and goes like it has a mind of it's own. I've checked resistance of the diff coil (25 ohms, in spec) checked for shorts, bought a new switch, checked continuity from...
View Article800 s motor swap upgrade
Has anyone swapped the 800s motor? What are the options as far as a motor swap?
View Article'15 900 Trail shocks on '11 800 Trail?
Will shocks off '15 900 Trail fit on '11 800 Trail? THE ANSWER APPEARS TO BE NO. WILL LEAVE THIS UP UNTIL I CAN FIGURE OUT HOW TO DELETE IT.
View Articlebig bore kits
hi everyone, my name is Aaron. my girlfriend has a 2013 rzr 800, looking to see if anyone can recommend a big bore kit, to give it a bit more power. I have put in a power commander as well, thx
View ArticleRZR 800 Exhaust
Hi, Anyone have a take off RZR 800 Exhaust system they want to sell? My RZR is a 2010 800. It has a Duel exhaust I would like to remove and replace with stock. Sounds great just a little loud for the...
View ArticleRear Inside CV Boot Torn
One thing that I usually do after my rides is to go over my RZR, and clean it up before parking it in my garage. So I come back from a nice leisurely ride this afternoon, and discovered that the rear...
View Article900 hubs ??
Anybody upgraded their hubs (the part the rotor attaches to) to 900 hubs ? I know the 900XP front bearing carrier and calipers will fit, but curious if the 900 hubs will work front and rear ? Also, is...
View Article800s problems
I have a 2012 800s and the throttle response has been horrible. I put a new clutch kit in it because I got bigger tires any suggestions. The throttle cable broke earlier today so Im gonna put it in...
View ArticleSteering issues
I have a 2014 800s with eps. Not turning very sharply. Will a standard 800s steering box work with my eps? Or is there a remedy to make mine turn better?
View Article